Quick answer
Green water is algae. It grows when free chlorine drops too low for your stabilizer (CYA) level. To clear it, lower pH to 7.2–7.4, raise free chlorine to about 40% of your CYA and hold it there, brush every day and run the filter around the clock until the water is clear. Most pools take 3–7 days.
Why pools turn green
Algae grows whenever chlorine falls behind: after heavy rain, a heat wave, a pump that stopped or a missed week of care. Stabilizer matters too. The more CYA in the water, the more free chlorine it takes to do the same work, so a pool with very high CYA can turn green even with chlorine in it.
How to clear a green pool
- Empty the skimmer and pump baskets, clean the filter, and run the pump 24 hours a day.
- Test free chlorine, pH and stabilizer (CYA). If CYA is over 90 ppm, drain and refill part of the pool first, or the chlorine can’t win.
- Lower pH to 7.2–7.4 so the chlorine works harder.
- Raise free chlorine to about 40% of your CYA (CYA 40 → 16 ppm) with liquid chlorine, and keep it there: test 2–3 times a day and add more whenever it drops. Add it at dusk, when the sun won’t burn it off.
- Brush the walls, steps and floor every day.
- Clean or backwash the filter whenever the pressure rises about 25% above its clean reading.
- Keep going until the water is clear, the overnight chlorine loss is 1 ppm or less, and combined chlorine is 0.5 ppm or less.
Chlorine levels for your stabilizer
Find your stabilizer (CYA) reading on the left. Keep free chlorine at or above the daily level every day, and hold the shock level to kill algae.
| Stabilizer (CYA), ppm | Daily free chlorine, at least (ppm) | Shock level for algae (ppm) |
|---|---|---|
| 30 | 3 | 12 |
| 40 | 3 | 16 |
| 50 | 4 | 20 |
| 60 | 4.5 | 24 |
| 80 | 6 | 32 |
Daily level: at least 7.5% of your CYA, and never below 3 ppm. Shock level: about 40% of your CYA. Salt pools usually run 4–6 ppm.
How much to add
| Product | What it does | Per 10,000 US gallons | Per 10,000 liters |
|---|---|---|---|
| Liquid chlorine, 10% | Raises free chlorine about 10 ppm | 1 gal | 1 L |
| Cal-hypo shock, 73% | Raises free chlorine about 9 ppm | 1 lb | 120 g |
| Muriatic acid, 31% | Lowers pH about 0.2 (with alkalinity near 80 ppm) | 12 fl oz | 95 ml |
Amounts are for the product strengths shown. Strengths differ, so check your label. Twice the water needs twice the amount. Add one chemical at a time with the pump running, wait, and test again before adding more.
The overnight test: how you know it’s over
Stopping too early is the most common reason algae comes back. In the evening, test free chlorine and write it down. Test again the next morning before the sun is on the water. If it dropped by 1 ppm or less and the water is clear, the algae is gone. If it dropped more, something is still using up the chlorine: keep going.
Can I swim in it?
Not while you’re clearing it. Don’t swim during a shock or while you can’t clearly see the main drain from the deck. It’s safe again when the water is clear, free chlorine is back between 3 and 10 ppm, and pH is 7.2–7.8.
Safety first
Read the product label every time and wear gloves and eye protection. Never mix chemicals, not even two kinds of chlorine: chlorine and acid together make a toxic gas, and some chlorines can explode on contact. Add each chemical to the pool separately, with the pump running, in different spots and 15–30 minutes apart. Always add chemicals to water, never water to chemicals. Keep children and pets away while you add them.
If a chemical gets in someone’s eyes or on their skin, rinse with plenty of water for 15 minutes. If someone breathes fumes, move them to fresh air. Then call your local emergency number or poison control center (in the US: 911 or Poison Control, 1-800-222-1222).
When to call a pool professional
Call a pool company if the water is so dark you can’t see the steps, if there are frogs or heavy debris, if the pump or filter isn’t working, or if the pool is still green after 5–7 days at the shock level. They can vacuum to waste and finish the job faster.
Common questions
How long does it take to clear a green pool?
Most pools clear in 3–7 days of holding the shock level, brushing and filtering. Very dark water, high stabilizer or a weak filter takes longer.
Why is my pool still green after I shocked it?
Usually the chlorine wasn’t high enough for the stabilizer level, or it wasn’t held there: one dose gets used up within hours. Test CYA, raise free chlorine to about 40% of it, and test and add 2–3 times a day until the overnight test passes.
Which chlorine should I use to shock?
Liquid chlorine is usually best, because it adds no stabilizer and no calcium. Chlorine tablets (trichlor) and dichlor shock add stabilizer every time, and cal-hypo adds calcium.
Still not sure? Ask Blue
Blue, the pool AI, answers in your language, reads a photo of your water or test strip, and works out the amounts for your pool’s size. Free.
Ask Blue freeRelated guides
- Green, yellow and black algae: how to tell them apart and kill them
- How much chlorine does my pool need?
- Cyanuric acid (stabilizer): how much your pool needs
- Cloudy or milky pool water: how to clear it
- All pool help guides
This guide is general information for home pools. Always follow your equipment maker’s instructions, your product labels and your local rules. Updated November 8, 2026.
