Get Started

Total alkalinity: the right level and how to change it

Quick answer

Total alkalinity (TA) holds pH steady. Aim for 60–90 ppm, or 60–80 ppm in salt pools, which push pH up. Raise it with baking soda (sodium bicarbonate). Lower it with muriatic acid over several days, letting waterfalls and jets aerate the water between doses so pH comes back up while alkalinity stays down.

Too high or too low?

Too high, and pH keeps climbing no matter how much acid you add. Too low, and pH swings up and down. Adjust alkalinity first, then pH, then chlorine.

How to raise alkalinity

  1. Test alkalinity and work out the rise you need (from 50 to 80 ppm is a rise of 30 ppm).
  2. Use the table: the baking soda amount raises alkalinity about 10 ppm, so a 30 ppm rise takes three times the table amount for every 10,000 of pool volume.
  3. Spread it over the water with the pump running.
  4. Let the pump mix it, then test again before adding more.

How much to add

ProductWhat it doesPer 10,000 US gallonsPer 10,000 liters
Baking soda (sodium bicarbonate)Raises total alkalinity about 10 ppm1.4 lb170 g
Muriatic acid, 31%Lowers pH about 0.2 (with alkalinity near 80 ppm)12 fl oz95 ml

Amounts are for the product strengths shown. Strengths differ, so check your label. Twice the water needs twice the amount. Add one chemical at a time with the pump running, wait, and test again before adding more.

How to lower alkalinity

It takes patience. Add muriatic acid in measured doses (never more than about 32 fl oz (950 ml) per 10,000 gallons (38,000 liters) at once), then run waterfalls, fountains and jets pointed up so aeration brings pH back up without raising alkalinity. Repeat over several days until alkalinity is in range.

Safety first

Read the product label every time and wear gloves and eye protection. Never mix chemicals, not even two kinds of chlorine: chlorine and acid together make a toxic gas, and some chlorines can explode on contact. Add each chemical to the pool separately, with the pump running, in different spots and 15–30 minutes apart. Always add chemicals to water, never water to chemicals. Keep children and pets away while you add them.

If a chemical gets in someone’s eyes or on their skin, rinse with plenty of water for 15 minutes. If someone breathes fumes, move them to fresh air. Then call your local emergency number or poison control center (in the US: 911 or Poison Control, 1-800-222-1222).

When to call a pool professional

Call a pool professional if alkalinity and pH keep fighting each other. A pro can balance all of the water chemistry for your pool’s finish, including calcium and the saturation index (LSI).

Common questions

What should total alkalinity be in a pool?

60–90 ppm in most pools, and 60–80 ppm in salt pools.

How much baking soda raises alkalinity?

About 1.4 lb (640 g) per 10,000 gallons (38,000 liters) raises total alkalinity by 10 ppm.

What is the difference between pH and alkalinity?

pH is how acidic or basic the water is right now. Alkalinity is the buffer that keeps pH from moving. Get alkalinity right first, then pH.

Still not sure? Ask Blue

Blue, the pool AI, answers in your language, reads a photo of your water or test strip, and works out the amounts for your pool’s size. Free.

Ask Blue free

Related guides

This guide is general information for home pools. Always follow your equipment maker’s instructions, your product labels and your local rules. Updated November 8, 2026.